17" 6335 3-Piece Split Alloy Wheels 5x205 PCD (Each)

17" 6335 3-Piece Split Alloy Wheels 5x205 PCD (Each) Three Piece Split Alloy Wheels The 6335. Face mounted with all flush fit hardware. Options for…

  • 050010124

  • Limebug

  • In Stock

£574.99

17" 6335 3-Piece Split Alloy Wheels 5x205 PCD (Each)

Three Piece Split Alloy Wheels

The 6335. Face mounted with all flush fit hardware. Options for Aluminium or Stainless Dishes.

Centres are supplied in raw centres, which are ready for paint, if you want polishing/ anodising please give us a call.

If you are looking for any specific dishes not outlined in the options, or want further dish options, finishes available, please send an e-mail or call us.

If interested please get in touch directly prior to purchase to discuss your needs and final application so your set can be tailor made to fit your application.

Specs Below:

- Wheel Diameter: 17"
- Wheel Width (J Value): Options Available
- ET (Offset): Options Available
- PCD: Option Available
- Centre Cap: Not Included
- Mounting Hardware: Available Separately
- Quantity: Listing for full Set

 Wheel Terminology, PCD, Offset, J & ET Explained

What is ET?

Often times you will hear people talk about ET on a wheel, it may seem strange that ET is actually the term for offset despite the abbreviation not resembling the meaning at all the reason for this is because it is derived from the german word 'Einpresstiefe'.

So next is understanding where to measure to and from. ET is always measured from the imaginary centre line of the wheel as you can see to the left. 

Nearly all wheels you will find will be positive offset, their is a number of reasons linking to better balance of rotating mass, caliper clearance and reducing the overall width of the vehicle, however there are some exceptions.

So for the measuring process for an ET45 Offset you would take your imaginary centre line and measure 45mm toward the face of the wheel and this would be the position where the hub will mount to the wheel. 

What is PCD?

PCD, or Pitch Circle Diameter is the diameter of which wheel studs are apart through centre of the hub. PCD fitments are a measurement showing the number of studs/bolts followed by the distance they are apart. The distance is usually shown in millimetres. So a PCD of 4x130 would mean that there are 4 studs or bolt holes evenly spaced around a circle with a diameter of 130mm.

What is 'J' Width?

The letter that typically denotes the distance between the rim edges, not including the rolled edge. The terminology refers to the sectional profile of the wheel, it just happens to be the point which most manufacturers use, probably because it is a relevant measurement for choosing tyre size and is a critical measurement far more than the lip itself which could vary massively from company to company.

width figures are easily calculated with a tape measure, and can normally be found stamped in the wheel, in the cross-section on the left you can see the area highlighted in red to visually represent where this measurement is taken from.


Product Code: 50010124
OE Code:
Any Questions, Please Contact Us Here

Classic VW Parts, Spares & Accessories
SERVICES

Amazing Customer Service

Everyone on our customer care team is an experienced VW owner and works in our office. Rest easy knowing real people are ready to help you.

Nothing is ever outsourced.View All Products

Latest How To Guide

Jim Dandy Rack Fitting Instructions

Jim Dandy Rack Fitting Instructions /Disclaimer   WATCH FOR SHARP EDGES. FILE IF NEEDED. ESPECIALLY ON THE 6 STRAIGHT TUBES!! FOR INDOOR DISPLAY PURPOSES ONLY!!   The purchaser (owner) of this kit assumes all liability in the assembly and use…

Read More